How to Go About Timber Floor Sanding and Polishing?

While installing timber, floors is easy sanding and polishing them and maintaining them is an easier job. If the quality of the timber is good a simple re-polishing can do wonders to enhance the look. Also, good quality floors need to be redone only once in 4-5 years. With continuous use the floor does develop a few scratches and marks. While some believe, this adds to the beauty of the natural timber some prefer their floor to be spic and span and sparkling always. Timber floor sanding and polishing can be done regularly to get the desired look and for sanding and polishing timber floors.

Floor

Things You Will Need-

• Sand paper/ steel wool

• Damp cloth

• Floor wax

• Polish

• Soft brush

Prevent Floor Mishaps

Prevention is better than cure and it is best to minimize the scratches so you don’t have to bother with too much polishing. The floor bears the maximum brunt in everyday use compared due to continuous movement. Pets and children can do things to the floor that one cannot even think of in their wildest dreams. However, this can be maintained with floor sanding and polishing and regular repairing. While warping and cupping are common problems faced by a lot of people, discoloring and unevenness are others. It is best to avoid the damage to the floor than repair it. For instance, pushing heavy furniture or pulling luggage or would make the timber floor susceptible to scratches or marks. Repairing timber floors and scratch marks would require professional help then.

Floor Polishing

Getting Professional Help

While a scratch is not deep, a gouge is a deeper mark on the floor where a bit of wood has been cut away. Scratches can be dealt with by using Timber floor sanding and polishing using scratch remover but gouges cannot be removed using these. One needs professional help to treat gouges, but scratches can be handled easily and since one cannot avoid them it is better to know how to keep them in check and repair them also.

Doing It Yourself Timber Floor Sanding and Polishing

Rough up the scratched area using a sand paper or steel wool. It is the corners in the scratch that are more difficult to remove thus they need to be covered too. It is important to either rub in the direction of the grain or in circular motion to avoid further damage to the floor. The dust particles can be then removed using a soft damp cloth. After the area, has dried we need to apply the scratch removal solution covering the whole portion with an even layer. This too needs to dry up before we use a paintbrush to touch up the floor with the original floor color. Avoid using brushes with hard bristles as it also causes scratches so you need to be careful while selecting your equipment. Also, the chemicals need to be used in the right quantity or else the scratch can look like an ugly scar on the floor. It needs to be just right to blend in with the rest of the floor.

Floor Sanding

Touch Up

Get floor polish and wax to touch up on the scratches when doing the timber floor sanding and polishing. This may need a little time and patience. Impatience can cost money and leave you with a bad stain on the floor. Often buying the right stain from the manufacturer along with an extra box of materials, while laying the new floor, proves helpful in sanding and polishing the wood floors. Though professional help is available, you can try for these Timber floor sanding and polishing too because they tend to be much more economical and provide a fine finish.